Minimal License Plate Frame

thingiverse

I was unimpressed by commercial license plate holders' messy tabs and mismatched borders, so I created this simple frame instead.\r\n\r\nThe design prints in two vertical pieces, with basic supports included. However, you might need additional supports for a cleaner rounded edge.\r\n\r\nWhere the two pieces meet doesn't line up perfectly, but it's hardly noticeable when attached to your car. In future reprints, I plan to add locking mechanisms at the back for better alignment.\r\n\r\nI printed this frame on my Rostock Max v2 with an e3d volcano hot end. To achieve a clean print, I highly recommend adjusting the extrusion width in the scad file. Single-layer wall thickness tests didn't go well, but that might be due to my printer's calibration issues.