Minimal Funko Pop Shelf

prusaprinters

While there is no shortage of Funko Pop organizers, shelves, etc., online, none of them were exactly what I wanted. So, I drew up this very simple design.Printed at 100%, it fits snugly around a standard Funko Pop figure in box with one of the collapsible pop protectors. This was not designed to fit the hard box protectors.I printed at 0.2mm 100% infill because I used translucent filament. If printing opaque, 20% infill is probably fine. There likely isn't all that big a difference in filament used, though.I simply attached to the wall with 3M command strips. Funko Pop figures don't weigh much so you could use just about any sort of adhesive mounting you prefer.