Mini Test block

thingiverse

Wanted a small test block to primarily assess filament appearance and print settings while minimizing the amount of filament used. This allows for an examination of the top, bottom, and side surface appearances from various angles. It tests low sloping angles, overhangs, bridging, and text printed on the top, bottom, and sides. The design also features a 3mm hole to test screw sizing. Printed using Prusa MK2S standard settings with a layer thickness of 0.20mm, it includes three layers at the bottom, three layers at the top, two layers on the sides, and 10% infill. It used 0.74 meters of filament and took approximately 22 minutes to print. The design was created in Tinkercad, where users can access measurements or make modifications if needed: https://www.tinkercad.com/things/1bIReeDrNqe