Mini Talon rear landing gear

pinshape

If you lose all your tail gear, you can cut the rest of it off and install this one instead! I was fed up with my tail problem for a long time. I tried every possible solution, but as I'm flying long-range missions with an 11,900mAh battery, which adds a lot of weight, and landing on rocky ground or asphalt always resulted in a broken or worn-out tail. So I cut out the damaged part and designed a brand-new tail. I secured it with two long screws and glued it in place too. It looks incredibly strong now. Printer Settings: Printer: Black Widow Rafts: No Supports: No Resolution: 200 Infill: 5-10% I printed my new tail gear with a wall thickness of 0.4mm and top and bottom thicknesses of 0.9mm. It's light enough and surprisingly strong. You can always decide to add an extra layer to the walls later, but I think it looks good as is.