Mini Talon R9 antenna support

thingiverse

Here's my small contribution to the Frsky R9 antenna (new ones) support.\r\nIt was created with the intention of installing it in the rear section of my mini Talon where a square pocket is located in the foam.\r\nThe design consists of two parts, one being the fixture and the other being the support itself.\r\n\r\nThe total weight comes in at less than 7 grams.\r\n\r\nTwo separate prints are required to print this model without any supports. If you're using ABS, you can glue the parts together with acetone slurry; otherwise, use epoxy for a stronger bond.\r\n\r\nThis is version 3 of the design, taking into account the length of the antenna cables for RX installation inside the deck. \r\nThe R9 Antenna will snap securely into place within the support, but it's recommended to add tape or elastic for added safety.