MINI Suspended Filament Vortex

prusaprinters

The DesignThe Mini Suspended filament Vortex is here! 50mm Diameter - 20-25 min print time. “Why? Can't i just scale the larger one?! ”Well, it's not quite as simple as that . Because each filament is modelled individually, scaling causes the lines to become smaller than the minimum extruded size. This can cause two issues, either the lines simply don't appear on the scaled model, or they are there but fail far too easily. So yes this had to be completely modelled again!This is a fun little desk piece.Let if you experience any issues.  PrintingThis was set up to be sliced in Bambu Studio or Orca SlicerSlice with the Arachne wall generator. Ensure layer thickness is at 0.2mm, Line Width 0.42Check the preview shows all of the suspended filament correctly The base is very fragile - take extra care when remove from the build bed.