Mini Skyhunter - Replacement wing attachment retainers

thingiverse

!!! ADDITIONAL HARDWARE REQUIRED !!! These have been designed to fit standard M4 nuts, so you'll need to purchase M4 screws of the correct length to make it work for you. You'll also need to drill out the white washers on the wings to 4mm. The print is tight enough that a press fit will keep the nuts in place, but your printer's tolerances might be different from mine, so I recommend securing the nuts with glue as well. You'll need both "rear attach" files because they're not identical; instead, they're symmetrical. I suggest gluing these parts into place using goop or some other slow-drying glue. This is because you should fit them into the fuselage and then immediately attach your wings, making sure to get the screws in place requires some movement plus or minus a mm here or there. Screw down the wings while the glue on these parts is still wet and malleable. Keep the wings attached until the glue sets, preferably overnight, to ensure that these parts are glued into exactly the correct position for your wing's screw holes. A minimum of 50% infill is recommended.