Mini Shredder V1

prusaprinters

<p>This is a mini-shredder I designed to shred garden catnip. I grow a lot of it, and using an “Herb” grinder was getting tiresome.</p><p>Tolerances are tight, so make sure you print with a well-leveled bed. No glue is necessary, the gears and rotors should fit snugly on the axle. You might need a hobby knife to bevel the rotors and spacers if you get some elephants foot.</p><p>Part quantities required:</p><ul><li>End Plate x2</li><li>Side1 x1</li><li>Side2 x1</li><li>Axle x1</li><li>Axle2 x1</li><li>Gear x2</li><li>Crank x1</li><li>Spacer x15</li><li>Rotor x15</li></ul><p>Fasteners required:</p><ul><li>12x M2 screws, length not critical as long as it's over 10mm. There's plenty of room for variance. It will work fine with 8x or even less if you're in a pinch.</li></ul><p>It will rotate stiff, but should wear in quickly enough.</p><p>&nbsp;</p><p>I'm working on a revised version that will be motor powered, and a loading hopper for the top.</p>