Mini nanoleaf LED lightshow (no soldering) with wall holder

thingiverse

This remix is a litle bigger, the triangles sides have 98mm, but you can mount your nanoleaf without any soldering. Soldering nanoleafs is a hard work, I've made one and boy the soldering part takes a lot of time. You will need to use the bellow ws2812b leds: https://pt.aliexpress.com/item/1005002322603523.html?spm=a2g0s.8937460.0.0.43362e0eeySBuZ They have a space between leds about 93mm (100mm center - center of leds) But if you want to use led strip (30 leds/meter) and solder the wires, the length of wire between leds will be about 80mm. UPDATED: New version v3 has 6 clips to make a strong hold between the base and cover. UPDATED (27/11/21): New version v4 has a better base and clip. The joining is very tight and the bases are kept togheter with no gaps, and the new clip is anti twist. Mounting Instructions ================ 1) Print the cover/base/hexclip 2) Begin mounting the clips on the bases on a flat surface, make sure the clips goes all the way to the bottom of the base 3) Insert the leds, begining with the one with the connector end following the outer perimeter of the base and them back following the inner perimeter of the base. 4) Insert the cover on all the bases 5) If you are mounting on a wall, you can print the holder as many you may need. The mount will fit on the hex format of the base and has a hole for a screw. If you don't want to use screw you can put an double sided adhesive on the base of the mount. MIXING with original thing: You can mix this remix (bigger) with the original thing (little), they have the same connections size, you can arrange interesting designs using both of them.