MINI-minda-holder with 3 deg offset.

prusaprinters

<p>Hot end clogs on the mini are attributed to heat creep and poor PFTE setup.</p><p>I've managed to fix this issue by not installing a aftermarket heat break but by adding better heat paste and re-routing the hot end - thermister and heater cartridge wires out of the immediate fan intake.<br><br>Re-routing the cables I've exceeded the original Minda mount structural limits and introduced a twist which had lead to a Minda misalignment. Probing still seemed to work but I did have one failure.</p><p>I re-modeled and introduced a 3 deg offset to re-align the Minda to the heat bed. This replacement still retains all original hardware.<br><br>Also increased the structure strength around fan attaching point as my original was cracked from the factory.&nbsp;</p><p>Added a cable cut out to reduce cable pinching between holder and fan shroud.<br><br>Minor adjustment to the Minda clamp to allow for an easier adjust and tighten.<br><br>Overall works well and I think is a great improvement over the original. &nbsp;I'll let you be the judge.<br>&nbsp;</p>