Mini Flamewheel detachable Mobius mount

thingiverse

Update 23.01.2015: Even stronger camera mount provides even less chance of tabs breaking and still requires minimal support. This is a bottom plate for the incredible Mini Flamewheel Quadcopter designed with great features. The Mobius camera mount smoothly slides into the gap on the plate and is held in place by two strong cable ties and two secure plastic nubs that are a little tricky to break, but I did my best without thickening up the entire bottom plate further. When using the camera, place the battery at the back for better balance. When not using the camera, the Mobius mount can be removed, so you can slide the battery forwards. This eliminates the need to fly heavily unbalanced or swap out the bottom plate entirely. Stick a strip of strong Velcro on the bottom of the plate to keep the battery in its proper place. The camera is mounted upside-down, so switch the 180° option in Mobius settings right away. Some minor sanding will likely be required for the cable tie "wings" on the mount if your printer struggles with printing overhangs without floating them. Of course, some support is necessary. Don't forget to also sand the small bumps at the front that hold the Mobius at an angle until you find it easy to remove the camera. Instructions Print with a moderate 30% infill in ABS if possible, as it's less stiff than PLA.