Mini Drone V1

thingiverse

I created this model after I destroyed my Hubsan X4 107C and wanted to build a replacement frame, so I purchased new parts and voila! 8mm motors fit perfectly in this design, which you can likely buy some parts for on Amazon and install into this "frame". I'm planning to print it tomorrow and test its functionality. Next, I'll be modeling battery and flight controller holders. If anyone has any suggestions or ideas, please let me know! Print Settings: Printer: Makerfarm Peg Rafts: Doesn't Matter Supports: No Resolution: 0.3, which can be finer if desired Infill: 100% spiralized outer contour Notes: Supports are only necessary if you have a lot of time and the correct file. Post-Printing: Assembling electronics I used a knife to carefully scrape the top of the motor holes, then inserted the motors and LEDs, followed by the board. After soldering, everything was ready for flight. A Word Of Advice: It's highly recommended to acquire spare propellers and motors, as reckless pilots like myself may encounter rapid propeller loss. Having extra motors on hand is also a good idea.