Mini Corner desk

thingiverse

This is a design based off my current desk in my room - a really cool little corner setup that's super simplistic and loads of fun. To put this thing together, we're looking at a total of 5 parts: First up, there's the main desk itself. This was printed with a 25% infill, but don't worry if you'd rather change it to something different - totally fine by me. And since I went for a .1mm layer height on this one, that's where we're gonna stick. Now, about the drawers: there are two kinds. We only need to print up one "desk drawer 2" (this is the bottom one) but for the top three, you'll need three "desk d". Once again, a 25% infill should do just fine here - same deal with that .1mm layer height, of course!