Mini B/T Rear Sway Bar

thingiverse

This is a sway bar mount and hardware for the Mini B or Mini T. If you have a hackfab rear tower then you will need to print that tower, it's all the same only taller. Parts you will need will be... 4 - tapered short screws (the same screw as the side rails on the cars) 2 - longer screws for the swingarm / links 1 - 1.25mm bar that I got at my local box store - I think they come in 2ft sections Some plyers to bend the bar to your own desire AND you will need to shave off some of the lower pivot block on your car where the little tab used to be (you need to remove it). The ball links on the metal bar will not be "locked in" and they will slide, this was how I designed it so if you want them locked in then that's on you to figure out. The bar should be cut so that they stick out the ends at all times. The swingarm screws will be just a smidge tight to keep them from rotating multiple directions, this will / should wear in and not bind in any way. you may want to print some extras in case they do start to wear out. The ball and socket should snap right in tightly and work itself free of defects without falling out. Good Luck and happy building