mini ar wing SMA holder

thingiverse

This is a quick SMA holder I made because I don't need to go miles and miles. Antennas are always best on the winds away from motors and other things that might interfere, but if you just want to try this out and fly, then this should be a good option. I printed it using PLA with supports and pushed it to where it was going to leave a mark, then used a sharp object like a drill bit and made holds so that the feed would go in. Once happy, not forgetting to make a hole for the SMA wire, I put some CP glue in each of the four holes, then installed it. If you find this print helpful, it would be nice if people could kindly TIP if they can. If not, then just enjoy it anyway.