MINI (1st Gen) Key lock button replacement

thingiverse

I'm so frustrated that the rubber button on my MINI key decided to rip and then completely fall apart...\nFor anyone else who encounters this issue, I've come up with a solution - a brand new replacement button!\nAll you need to do is print both parts (the outer ring and the button) then carefully cut out any remaining fragments of the rubber button, leaving only a small engraved ring around a hole (As shown in the second picture)\nNext, slot the outer ring into this hole and push the button through the hole left (With the flange on the bottom to prevent it from coming loose)\nTest the key and if everything works, then remove the button again and apply a small amount of glue to the outer ring and stick it to the key. I used superglue gel.\nIncluded is Button MK1.1 and Button MK1.2\nButton MK1.1 will need some sanding on the bottom flange, whereas Button MK1.2 shouldn't.\nButton MK1.2 has a rounded top to the top of the button.\nPrint Settings\nPrinter: \n Wanhao D4S\n \n Rafts: \n No\n \n Supports: \n No\n \n Resolution: \n 0.1\n \n Infill: \n 25\n \n Notes: \n I slowed the print speeds down to about one-quarter for all speeds.