Mingda Magician X - Gantry Support Remix

thingiverse

This is a remix for add gantry support for Mingda Magician X. I use two M10 threaded steel rod (47.5 cm long) and four M5 screws for bottom Printer: Mingda Magician X Rafts: Doesn't Matter Supports: No Infill: 20-30% Notes: Take care that the dimensions of the holes fit your screws etc. Recommended print-options: [X] outer before inner Walls (hanging holes - prevent printing into air) [X] connect infill lines (lots of small fragments at infill) Assembly Insert nuts into the bottom mounts (if not snuggerly held, ensure the fit.) a.) screw + b.) clamp together bottom mounts onto the printer a.) Insert nuts into Topmount; Pressfit. b.) screw topmounts on frame - care for tight z-belt screw two nuts onto the aprox. 605 mm rod - from both ends so they don't block further assembly screw rod into the top part till you are able to insert it into the bottom mount; screw it into bottom mount, take care that the rod gets cought by the inlay-nut. Don't overscrew it, for it will force itself in a 10° angle into the printer and damage the surface. If the rod is securely in the upper and lower hidden nut, tighten the nuts you previously inserted onto the middle of the rod. TAKE CARE NOT TO OVERTIGHTEN THE NUTS SINCE IT BENTS THE GANTRY For the original installation guide look at the original project to https://www.thingiverse.com/thing:4243350