Minecraft skeleton with bow

thingiverse

My daughter insisted that I create this, and I was determined to add a gap between the bottom ribs - but I was warned against it with severe consequences if I failed. I came across several similar designs here, but they were all relatively small (this one stands about 130mm high) and solid (this one is semi-articulate). I can also print it left-handed if you prefer. The model in the images was printed using glow-in-the-dark filament. Print Settings Printer Brand: Ultimaker Printer: Ultimaker 2 Rafts: No Supports: Yes Resolution: 0.2mm Infill: 25% Post-Printing Joint Fitting A few people have left comments on my previous designs because of the need to drill holes or sand down pieces due to poor fitting. I designed this model specifically for my calibrated printer, and it has been fine-tuned as much as possible. There are intentionally loose gaps in the joints, but they should fit together tightly. However, since my printer's tolerances are quite good, you may need to sand down the pins or drill out a few holes slightly to get everything to fit properly.