Minecraft Pumpkin and Jack-o-lantern, reduced support version

thingiverse

NEW FOR 2018! MINI NO-SUPPORT VERSION IS HERE!!! My original Minecraft Jack o'Lantern required a lot of support to print, making it a real hassle to remove. This design is a total game-changer - it prints in two parts that can be snapped together with only about half the amount of support needed. To get started, print the base without any support at all. The other parts will probably need some support depending on your printer's ability to handle overhangs. You'll likely want to use around 25% infill to avoid certain thin parts snapping off while assembling. Just be sure to assemble the "face" and "jaw" with great care! Slide the top onto the base straight down - try not to let one side slide down before the other, or those small parts on the corners might snap off. If they do, just glue it together and blame me. Don't even think about using a real candle, of course - consider either these flickering LED tea lights or print some of Skriver's LED lights with some LEDs that have integrated flickering built right in. I'm hard at work on a smaller version that integrates the LED and battery into the pumpkin itself. Stay tuned!