Minecraft Enderman - Textured - Articulated

prusaprinters

<p>This thing is built from the ground up around the Lego Technic Pin (<a href="https://www.thingiverse.com/thing:1956475">https://www.thingiverse.com/thing:1956475</a>) for the leg, arm and neck joints. The texture was developed from a folded paper example I found online.</p> <p>I had the texture too deep for V1 so I reduced it by 0.5mm for V2. I also made the pin holes and shoulder recesses 0.05mm deeper to maybe get a better fit.</p> <h3>Print instructions</h3><h3>Category: Toys &amp; Games Summary</h3> <p>This thing is built from the ground up around the Lego Technic Pin (<a href="https://www.thingiverse.com/thing:1956475">https://www.thingiverse.com/thing:1956475</a>) for the leg, arm and neck joints. The texture was developed from a folded paper example I found online.</p> <p>I had the texture too deep for V1 so I reduced it by 0.5mm for V2. I also made the pin holes and shoulder recesses 0.05mm deeper to maybe get a better fit.</p> <h3> Print Settings</h3> <p><strong>Printer Brand:</strong> Creality</p> <p><strong>Printer:</strong> Ender 3</p> <p><strong>Rafts:</strong> No</p> <p><strong>Supports:</strong> Doesn't Matter</p> <p><strong>Resolution:</strong> 0.2</p> <p><strong>Infill:</strong> 10-15</p> <p><strong>Filament:</strong> FilaCube PLA+ Black<br/> <strong>Notes:</strong></p> <p>I didn't have a reference scale other than the proportions needed for the pin joints so it probably won't scale to other Minecraft characters.</p> <p>I only needed supports for the limbs, but YMMV.</p> <p>Printing the limbs w/ the hole facing down uses the fewest supports, but doesn't make for a clean pin socket. It will keep the roughest side of them facing in and less noticeable though.</p> <p>Pin to socket clearance will depend on your printer. When I printed V1 the joints didn't quite seat properly and were a bit too loose. Hopefully V2 fits better.</p>