Minecraft Chest Satchel

thingiverse

Hey guys! Check out this 3D modeling contest entry I came up with for iD tech - unfortunately, it didn't take the top prize, but that just means I get to share it with all of you instead! The print comes in two parts: the upper and lower sections. To assemble it, simply line up the six holes and snap the upper part into place. For added stability, consider gluing it down so it stays put. A joint is already built into the design, allowing you to open and close the satchel with ease, while holes on the side provide attachment points for any straps you might want to add. I'm unable to print this model myself since it's too large for my printer, but you may need to scale it up if you find it's a bit too small to wear comfortably. Support material is recommended, but it's not strictly necessary - most of the design consists of vertical elements with minimal overhang, so you might get away without them.