Minecraft Chess Set (Magnetic)

thingiverse

#Minecraft Chess Set (Magnetic) This is a Minecraft Chess Set with magnets in each piece. I used most pieces from PotatoFi's set found here, https://www.thingiverse.com/thing:143991 With the addition of a crown from Will Schleter's additions here, https://www.thingiverse.com/thing:922419 I used a Pumpkin Head for the King/Enderman. I created a round base with a cutout on the bottom for a 4x2mm magnet for use with the King/Queen/Enderman and Bishop/Skeleton. I replaced the Rook/Creeper, Pawn/Slime and Knight/Zombie Body with versions that also have a cutout for a 4x2mm magnet on the bottom. I found that the friction fit of the heads on these models is very filament dependent. You will likely have to experiment between 100%-110% in order to get the heads to friction fit well. I also found that printing a single head did not allow enough drying time between layers of the head pin, the headpin would deform, and therefore printing 3 or 4 heads at a time was required. The heads and magnets are friction fit while the bases are glued on with Crazy Glue. The magnets were gently hammered into place while supporting the base, I also ensured that all magnets were inserted with the same polarity orientation, though I'm not sure why I bothered with that. I found a 12.6" folding magnetic chess board works well for this set and fits all pieces for travel.   # Parts   *4x2mm Magnets* https://amzn.to/3OMsPAf *12.6" Magnetic Black/White Chess Set* https://amzn.to/3IvQOjb   # Please Support in the following ways *Subscribe on YouTube* http://youtube.com/substatica?sub_confirmation=1 *Buy Me a Coffee* https://www.buymeacoffee.com/substatica *One Time Donation* https://streamlabs.com/substatica/tip https://paypal.me/substatica *Merch* http://store.substatica.com