Mind Your Business Coin

thingiverse

I managed to get BronzeFill to stay on the tape, but it wasn't easy, so I tried using a gluestick and that helped somewhat. The CopperFill seemed to stick better to the plate than the other one did. It didn't seem to matter if the bed was heated or not. Cura 2.3 was used as the slicer software. To get a decent print, I ran at 80% speed. I also increased the flow rate to 105% to improve the fill quality. However, some of the letters still don't have complete fills. I sanded down the print using progressively smaller grits, from 320 all the way down to 60,000. After that, I used the back of a spoon to smooth it out even further. My next step will be either building or buying a tumbler to see if I can get them shining in some way. Print Settings: Printer: Monoprice Select Mini Rafts: Yes Supports: No Resolution: 0.175mm Infill: 100%