Milwaukee Packout Impact 1/2

thingiverse

1/2 inch impact sockets. I got the sockets from harbor freight... I know, but I don't need high speed stuff. Deep sockets 24mm, 22, 21,19, 17, 15, 14, 13, 12, 11 Pittsburgh Pro. Other sockets 22mm, 21, 19, 18, 17, 16, 15, 14, 13, 12, 11, 10 Pittsburg Pro. The fit well and if you shake it up only two sockets will fall out of place but when laid back down to open they will fall right back to place. easy fix its to add a small plastic cover on the inside of the lid. This was printed in two efforts, went with a RAFT start PLA, 219, bed at 63, and went slow to avoid warping. I had to round off the middles because the corners were causing the plastic to not sit well and rise up. When you use raft don't worry about getting the edges on the side cut off perfectly, some of the residual will actually cause it to sit SNUG inside the Packout.