Milwaukee M12 Gen 3: 3404 Drill/Driver, 3453 1/4" impact, and 2554 3/8" Stubby Impact

thingiverse

Needed these for the Gen 3 tools. Printed on a Bambu Labs X1C All three mount holes are spaced for 1in pegboard. Still figuring out where I want to mount these in my garage. Put flat spot on bottom of mounts for supports. Model #3404-20 M12 Drill/Driver -Fits a little loose but the seems to work well with a bit installed. I know the 3404 model sits a little higher if you mount all three together. Might go back and change it so they all sit about level if you put them together on the wall. But if it's mounted on a wall and not the edge of a table as shown on the original design, then it doesn't leave much room if you have a drill bit or something inserted in the chuck. Model #3453-20 M12 1/4" Hex Impact -fits pretty snug with the rubber pads on the tool. Model #2554-20 M12 3/8" Stubby Impact -scaled the tool holder up 112% to fit the rubber boot on the stubby impact. -includes model for with or without rubber boot