Milwaukee drill mount

thingiverse

I recently stumbled upon a holder design: https://www.thingiverse.com/thing:882861 and found that while the concept was excellent, it wasn't very practical for my needs. I printed two of them and discovered they were just a bit too small for my drivers, and the offset mount would break easily when bumped into. So I decided to create my own from scratch in Fusion 360. The flush mount design should provide better durability and minimize its presence on your bench or wall. It's slightly oversized, but I figure it will also accommodate different drivers by various manufacturers. There is absolutely no chance of the driver falling out on its own. I'm sharing two versions - the first has an opening for the handle to come out at a 90-degree angle to the surface you attach the mount to, and the second has the handle parallel to it. I haven't tested the second one yet, but I am starting that print now and will update if needed. I didn't need supports for this print, however your experience may vary depending on how well your part cooling is and how smooth you want it to look when it's done.