Millright Mega V touch plate holder and magnetic probe

prusaprinters

<p>This is a simple holder for the stock Millright Mega V touchplate, as well as a magnetic replacement for the probe alligator clip.</p> <p>The holder has a small, thin magnet to hold the probe, but you can skip that and stick it anywhere.</p> <h3>Print instructions</h3><p>Uses one 8mm x 3mm magnet for the probe, and one (optional) 8 x 0.8mm magnet to stick the probe to the side of the holder.</p> <p>Solder wire to 8x3 magnet. Best to do this with the magnet attached to a stronger magnetic source so that it does not lose its magnetism when heated with the soldering iron.</p> <p>Feed wire through holder through the front and press soldered magnet in place. Feed wire through strain relief and CA glue the back onto the probe.</p>