Milk Frother

thingiverse

This device creates high-quality, consistent foam for espresso drinks with ease. I simply inserted it into a drill and within a minute, the milk had doubled in volume.\r\n\r\nTo complete this build, you will require two lightweight springs. The ones used were 40mm long when uncompressed, 6mm in diameter, and featured a wire outer diameter of 0.5mm. After printing, thread the spring onto the part as depicted in the accompanying pictures. \r\n\r\nUse food-safe filament such as PETG and ensure that the print is as smooth as possible. Milk left in small crevices within the part could facilitate bacterial growth; therefore, please make sure your prints are smooth and consider applying a food-safe coating if possible. \r\n\r\nI discovered that it works best to utilize 2% milk at 150 F (65 C).