Military ribbon racks (afjrotc)

thingiverse

All sizes from a standard 3 bar which you should only print for calibration are attached. it works just fine with afjrotc ribbons. there is no spacing as that is not in my reg, if you want me to make ones that are left justified or have spacing just comment. these are way cheaper to make as the metal ones you can buy and work just as well. older versions did not have the back completely covered and were still rigid enough i just added the full back for ease of modeling. in order to complete take pins (i used ones looted from 1 bars just pulled out with pliers you can also buy them on amazon for cheap though) then push it through one of the holes with a soldering iron (i'm sure you could also do it with your printer somehow if you don't have a soldering iron.) comment any concerns and ill try to fix them.