MikroTik hEX S 10 inch rack mount

prusaprinters

This is a 10 inch rack mount for the Mikrotik hEX S router, also fits the regular hEX (thanks therealodie for testing) might fit for others as well but thats untested.You'll need 4 M3x8 screws and 4 M3 nuts.Print SettingsSupports:NoResolution: 0.2Infill:15%Filament:PETGNotes: print two pieces of rack-plate.stlInsert hEX SThis can be a bit tricky.align the holding pins on the center part to the screw holes on the bottom of the hEX S and push them in (this is why you should use PETG as it bends better)while pushing, slide the hEX S to the front until the rubber feets lock into the holes. This is a little difficult because of the rubber feet.the hEX S should now be securely locked on the mountscrew togetherUse 4 M3x8 screws and M3 nuts to screw the rack plates to the center piece.