middle section #3

thingiverse

Instructions for Creating a Customized Mechanical Fingernail Extension To make your mechanical fingernail extension using this customized model, follow the instructions below: Choosing Options To adjust the dimensions and features of your extension, use the following settings: - Hinge pin radius: 1.075 millimeters - Middle length: 20 millimeters - Build item quantity: 3 - Rotate test setting: Off - Socket thickness: 2.1 millimeters - Socket hinge notch depth: 0.75 millimeters - Number of middle sides: 1 - Scallop offset: 3.5 millimeters - Print mode selection: 1 - Hinge nut thickness: 2 millimeters - Hinge width: 14.5 millimeters - Base width: 17 millimeters - Socket depth: 26 millimeters - Number of knuckles: 2 - Tip length: 15.5 millimeters - Radius of the tensioner screw for tip nail extension: 0.85 millimeter - Radius of the base tensioner screw: 0.85 millimeter - Middle width: 7 millimeters - Ratio of the fingernail on the end to its full height: 55% - Width of the top surface of socket at its midpoint: 16.75 millimeters - Height and angle of the nail ridge tip in mm and degrees respectively - Radius of additional accessory placed at tip if present: Not applicable as default settings use. - Full width of the end or terminal part in mm - Right and left hand setting respectively in case one prefers mirrored symmetry, measured by millimeters and adjusted with scallop_left: 0mm. Setting is adjusted on left hand for demonstration, mirror to adjust based upon preference using scallop_right - Middle section height (of mechanical finger or its extensions) - Hinge plug thickness to cover the top part which includes pin screw area where necessary: 2.2 millimeters. - Width of the bottom socket in mm and setting depth not exceeding tip width +5% for standard application on bottom part for clearance:24 - Amount that plugs should be thick as default settings have small variation and extra allowance to compensate using value set for hinge_plug_bulge - Total length up the middle area at about center for a more aesthetically pleasing nail shape measured by millimeter value:6. - Size of radius in hole of tip's accessory when it reaches bottom. A default is assumed at tunnel_radius =1.2 and that it also applies with a standard setting based upon dimensions used for the other accessories for tip_accessory_radius which equals to zero so no size has to be manually provided in code. Exploding Feature A default exploding option value has been disabled to turn the mechanical fingernail on, you might still change your settings or switch to on state and disable as a user according to your specific requirement if this applies based upon what one desires with regards to feature preferences during use and printing