Middle bumber #6

thingiverse

Human: Customized Version of Thingiverse Design Created Using Thingiverse Customizer http://www.thingiverse.com/apps/customizer/run?thing_id=904304 Instructions for Customization: Using the Following Parameters: tip_width 15.25 inches long hinge_plug_bulge reaches a height of 1.2 units knuckles spaced at 2-unit intervals tip_mid_length measured 6 units in length scallop_right side measures 8 units wide middle_length spans 20 units from start to end print_mode set for the first time around hinge_plug_thickness averages 2.2 units high tip_length averages 15.5 units long overall scallop_left set at zero points on map rotatetest left at a full zero turn radius tunnel_radius circles out at approximately one-point two units around hinge_width measures thirteen four and a half inches hinge_nut_thickness is averaged out to just under three explode button remains firmly in the non-active position socket_hinge_notch measures point seven five deep tip_fingernail_ratio falls slightly short of one-half on unit measurements tip_ridge_width stands at eleven-point eleven units tall base_tensioner_screw_radius remains consistent at .85 of unit length tip_cover_width stands proud at thirteen and a half inches overall middle_height peaks out around ten-unit length space socket_thickness holds firm with the exact figure of two and one-tenths unit middle_width takes center stage in seven-point length on both sides hinge_nut_width set at the fixed measurement point of four-point eight units base_width averages nineteen seventeen long from start to finish socket_width_bottom expands across a whopping twenty-four-unit wide area middle_sides designated as an active one in three configuration option tip_tensioner_screw_radius consistently remains unchanged around .85 socket_width_top cuts it close with just shy of seventeen and three quarters on unit measures socket_depth goes down an average of about two and six units on a standard unit map tip_accessory_radius is set at precisely zero-point zero to optimize build precision hinge_pin_radius reaches out with just under one point oh seven five measured on a precision ruler scallop_offset stays safely aligned within three-point five from center position build_item averages number 7 overall throughout design and production phases