microswiss Ng 5015 abl

thingiverse

Microswiss NG fan mount for a 5015 parts cooling fan. This was designed for the Ender 6 but should work on other printers as well. Added a removable bracket for a bl or cr touch. Cropped lower end for better view of the hotend, and added a mounting ledge for an adxl345. Fan ducts are tuned for more even airflow distribution. 100% clearance in all directions. Print with at least 4 walls and do not reorientate the models, supports touching bed is required, do not use add supports everywhere. There are 3 different versions of the fan shroud, one for a Creality factory hotend fan with the wire on the right side with a channel provided for wire routing. Another that has a hole for running the wires through, this looks better but requires cutting and splicing of the fan. Finally another design for left wire fans with a channel provided. Uses oem screws for hotend fan and an oem screw for right shroud mount. Left screw mount will need to be 10 mm long if using the abl bracket. abl offset is x-47 y-8 Screws needed for install Abl bracket mount to shroud front screw M3 x 10mm x 1 Abl bracket mount \ shroud back screw M3 x 10mm x1 BL/Cr-Touch to bracket mount M3 x 6mm x2 5015 fan screws M3 x 20mm x2 5015 fan nuts M3 x 2 Adxl345 screws M3 X 4-6 mm Install order- Attach Cr touch to abl bracket with two m3x6mm screws, Attach abl bracket to housing with single m3x10mm screw that faces x axis, hotend fan to shroud, 5015 fan to shroud using m3x20mm screws and nuts, attach top right shroud mount m3 screw to carriage, attach lower left shroud mount m3x10mm screw to carriage, MOUNT adxl345 LAST! MicroSwiss_NG_NOCUT = Channel provided for hotend fan with wire on left side MicroSwiss_NG_CUT_FAN = Hole provided for fan wire that you must cut - better looking MicroSwiss_NG_LEFTWIRE = Channel provided for left wired fan - Looks the best - must install fan before mounting to carriage. Microswiss_NG_No_Abl.stl = modified shroud with no abl mount - for use with my linear rail abl mount.