Microsoft VX-xxxx mount

thingiverse

Added a hole in the center to accommodate the pin's return, that area needs to be narrower for the pin clip to function properly. I didn't bother as the pin is retained by the circuit board and friction. Added a mounting bracket to the back so it can be used with this device, https://www.thingiverse.com/thing:2516411. It should work with most Microsoft VX-xxxx models that feature the rubber boot leg accessory. To disassemble: 1. Remove the silver ring by prying it loose since it's only glued on. 2. Unscrew the two screws visible and take off the cover. 3. Unscrew the next three screws and remove the outer cover. 4. Remove the next three screws on the circuit board, then carefully take out the board. 5. Pull out the clip holding the original mount in place and remove the pin. 6. After installing the printed mount, do everything in reverse.