MicroSD Card Holder Container

thingiverse

I loved the MicroSD Card Holder created by bgill, but some MicroSD cards were thicker than others and some would jam. My solution was to modify the existing model to make it a bit bigger so that the card would slide in and out much easier. The cards will all fall out if turned upside down, which is why you use the lid! The black dot on top was drawn with a felt pen, indicating which way up to hold it to locate a specific card. Printer Details Printer Brand: RepRap Printer Model: Wanhao i3 v2 Rafts Used: Yes Supports Used: No Resolution Setting: Fine Infill Percentage: 20% Printing Time: Bottom Part: 10 hours Top Part: Approximately 4 hours