Microphone shock mount

pinshape

These mounts can be pricey and they have a tendency to vanish quickly, so... another plea from my IT department is to create a 3D printable version. Lots available on Thingiverse, but I'm up for the challenge! This mount fits into a standard Flash Shoe mount, with a Ninjaflex clamp ring that attaches securely and a collar to isolate the mic from any vibrations (tan colored parts). All the parts are designed to thread or slot together - no adhesives should be needed. All the parts can be printed without supports at 0.2mm (or higher for threaded parts). Print the Flash shoe mount with 100% infill for added strength. The mic clamp is attached at the hinge by a metal pin (see part photo), and I discovered that a cut-down large paper clip worked perfectly (1.75mm dia). Print using your preferred strong filament. I used Faberdashery Classic Black and Caramel Ninjlex. http://www.faberdashery.co.uk/products-page/print-materials/classic-black/ http://www.fennerdrives.com/%20ninjaflex3dprinting/_/3d// Note: This mount hasn't been fully tested, I will post updates if the design evolves.