Microphone / PA stand base

prusaprinters

<p>Base of the microphone stand. This base is used also for PA stand. Just add tubes, bolts, nuts, and piece of rubber.</p> <p>Brake is part of source code. Divide it from the main body in the code or use "Split to objects" in slicer (Slic3r). Glue a rubber to the brake so it breaks much better. Break hull accepts hexagonal nut. You can change it to squared nut in the code.</p> <h3>Print instructions</h3><h3>Category: Music Print Settings</h3> <p><strong>Rafts:</strong> No</p> <p><strong>Supports:</strong> Yes</p> <p><strong>Notes:</strong></p> <p>Model includes simple support. One layer thick support is easy to remove and helps with print a lot.</p> <p>If the legs have big diameter (e.g. 20 or more), use supports (on built plate only) to catch the bridges. Otherwise, bridges (and few layers above) fall down a little during printing and lift up a lot during cooling. The upper layers will then hit the nozzle. This is a must for printers without springs in the bed (Prusa etc.).</p>