Microchip Snap In Programmer / Debugger Case

grabcad

This case is a remix of MPLAB SNAP CASE by sparky_summer on Thingiverse: https://www.thingiverse.com/thing:4848313The main reasons for this remixed model:1. thicker vertical walls and thus less likely to break2.polarized connector (plug) to avoid inversion3.switch to change operation mode, PIC/AVR (Some Snap In models do not have this 3-pin jumper on board).Switch: https://pt.mouser.com/ProductDetail/CK/JS202011SCQN?qs=LgMIjt8LuD95JYWxZ7NvZA%3D%3DThe parts were printed on an FDM printer in PLA and with a 0.3mm layer without supports, except the cover that was printed with the external face up (in my case because i wanted this face perfect)Finish: water sandpaper (400, 600, 800) to get sides perfect, finally, several coats of cellulose varnish were applied at a distance of 30 to 40 cm to obtain a slightly rough appearance.