Micro Tricopter (Sub-250g)
prusaprinters
Printed in PLA with 2 shells, and ~10% infill at 215C(Slicer settings will need tweaking for optimal strength)Non-printed parts list (Some parts may be substituted):8 M3 Nylon Nuts4 M3x16mm Screws3 Brotherhobby Returner R3 11063+ Compatible PropellersMG90S Servo3 ~6A ESCAikon F4 Flight Controller30x30mm Mounting Hole Power Distribution BoardFemale XT30 ConnectorSome ~22 Gauge WiresSome ~18 Gauge Wires~850mAh 3Cell LiPoCompatible transmitter/receiver for your remoteSmall ~10cm ZiptiesSome notes on assembly:The servo horn will need to be trimmed and CA glued to the rear motor mount(The servo horn screw is still acessable)I cut the servo wire and used the header to mount the transmitter/receiverMy Assembled Weight: 168.9g (My vary based on a lot of factors)Message or comment any (hardware) questions you haveThe tethered test flight was sketchy software and control-wise but the frame held up.Note:Betaflight doesn't like me or my weird servo setup.Any help regarding getting betaflight to play nice would be appreciated
With this file you will be able to print Micro Tricopter (Sub-250g) with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Micro Tricopter (Sub-250g).