Micro Tricopter (Sub-250g)
thingiverse
Designed this to try and 3D print a sub-250g tricopter (Transport Canada Reg.) Non-printed parts list (Some parts may be substituted): 8 M3 Nylon Nuts 4 M3x16mm Screws 3 Brotherhobby Returner R3 1106 3+ Compatible Propellers MG90S Servo 3 ~6A ESC Aikon F4 Flight Controller 30x30mm Mounting Hole Power Distribution Board Female XT30 Connector Some ~22 Gauge Wires Some ~18 Gauge Wires ~850mAh 3Cell LiPo Compatible transmitter/receiver for your remote Small ~10cm Zipties Some notes on assembly: The servo horn will need to be trimmed and CA glued to the rear motor mount (The servo horn screw is still acessable) I cut the servo wire and used the header to mount the transmitter/receiver My Assembled Weight: 168.9g (My vary based on a lot of factors) Message or comment any (hardware) questions you have The tethered test flight was sketchy software and control-wise but the frame held up. Note: Betaflight doesn't like me or my weird servo setup. Any help regarding getting betaflight to play nice would be appreciated
With this file you will be able to print Micro Tricopter (Sub-250g) with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Micro Tricopter (Sub-250g).