Micro Skyhunter fuselage

thingiverse

I've got a lonely micro Skyhunter wing and some old parts just collecting dust, so I printed a fuselage for it. **Note**: I haven't flown or assembled this yet, so your results may vary. If you're adventurous enough to try it out, be prepared to make some changes. Designed for the following parts: 30.5mm flight controller, an old full-size ESC mounted on the outside, an old TS832 also on the outside, a supercheap microcamera, the innards of an M8N GPS puck, a miniquad motor with the aluminum mounting plate that comes with Sunnysky motors, and a DIY "triangle" 18650 battery. Possible problems I see after printing it: Wing attachment screws may not hold, motor mounting, jointed part... Print the single piece version if your printer is big enough. The lid needs to be rotated upside-down for printing. I used 0.12 mm layer height; I'm not sure if the details will survive with bigger layer heights. Supports probably won't be required, depending on your printer. Fusion 360 file included. YMMV...