micro SD card tray for Anet ET5

thingiverse

Dont want my sd card to go inside the printer anymore, so I made this thing to guide the card into the slot. Initially I took https://www.thingiverse.com/thing:3590408 as a base, removed the parts that are not needed and printed it. ... Long story short - I took the callipers and made this model. Thinest wall and thinnest layer of the model are 0.6mm, so make sure that wall_thickness and wall_line_count is ok with that. I printed it with: * 0.6mm nozzle * 0.2mm layer height * 0.6mm wall width * wall line count =1 The model was laying on the side that is visible. Obviously, I could have printed it with finer settings. If I have to do it again (it takes like 2 minutes to print, but I'm lazy), I'd print it with the visible side up (and some support), with 0.4mm nozzle, with PETG, as it is softer and fitment to the printer would be easier. Edges of the part that enters the Anet case are intentionally not round, you may need to sand/file them to fit your printer.