Micro Pop-Up Book

cults3d

A miniature pop-up book printed in several parts. No supports needed, but will require a few drops of glue. Please read entire description before downloading. Works best if both covers open at the same time while laying on the spine. If you print with too much elephant footing the book may not close 100%, same thing if you paint as thick as me. Assembly: 1) *IMPORTANT- Book cover is three separate parts that need to be snapped together. It is a very tight fit and goes together best with a zipperlike action that still requires some considerable force. Once together the hinge is very strong. Be careful not to put force on the raised "pages". 2) Once book parts are together, slide the pins through the rectangle with holes and glue them into their upper corner housings. 3) Slide castle onto one pin all the way, then angle the castle and slide onto the other pin. 4) Glue two towers into place on book spine. 5) Glue trees and dragon where you like, but must stay clear of castles movement and each other while closing. If you have any problems let me know.