Micro C-130 Hercules RC model

cults3d

EDIT - 15.03.2020: Added new wing parts that can be printed completely with vase mode for improved print quality and easier printing with LW-PLA. Also added Aileron02 and Elevator02, which print in one piece for vase mode, and require separation after printing. Wingspan: 610 mm Length: 433 mm AUW: 100-115 g CG: ~20mm from the leading edge of the wing center section. For experienced users. It requires basic modeling skills to set up control surfaces and build the plane. I have not flown the plane under power yet, but I have flown it freeflight with ballast and AUW 109 g. It flies well. Print settings: My prints were all made on normal printers with normal PLA and 0.4 mm nozzles. You can print thinner than 0.4 mm perimeters just fine with a 0.4 mm nozzle. Print most parts with one 0.25 mm perimeter and 0.12 mm layer height. Use two bottom layers and four top layers for most parts. Add top layers as necessary to fill the top. Print Fuselage02 with no top layers. Fuselage01 will go into the open end of Fuselage02. Cut away the bottom layers after printing to lighten the model, as shown in the photo of the backside of the green part Fuselage01. As a reference, Fuselage01 should weigh ~6.5 g off the printer and ~5.5 g after trimming down the rear face. I use scissors like these to cut around the inside: https://www.ebay.com/itm/Curved-Lexan-Scissors-RC-Car-Bodyshell-Cutting-For-Polycarbonate-Shells-Arches-/371079169069 Hinge elevators with Blenderm on the top surface. Hinge ailerons with Blenderm on the bottom surface. Hinge the rudder with tiny pieces of CA hinge. Use 0.8 mm piano wire to connect the elevators together. Use 0.8 mm piano wire to create a torque link to the rudder. Use 0.8 mm piano wire to create torque links to the ailerons in the slots in the bottom of the wing. Required hardware: 1 mm carbon rods 2 mm carbon rods 3 mm carbon rods 0.8 mm piano wire CA glue CA hinge Blenderm hinge tape Can be used with 8.5 mm coreless motors or tiny outrunners: https://hobbyking.com/en_us/turnigy-d0703-10000kv-brushless-motor.html?affiliate_code=BSFWYBUNYWDKXJN&_asc=5338582182 Suggested electronics: Receiver and rudder/elevator servo: https://www.banggood.com/custlink/33K3dSpugG Aileron servo: https://www.banggood.com/custlink/vGDmdSrueL 450 mAh 1S lipo. Motors: https://hobbyking.com/en_us/turnigy-d0703-10000kv-brushless-motor.html?affiliate_code=BSFWYBUNYWDKXJN&_asc=3215844319 ESCs: https://hobbyking.com/en_us/yep-7a-1-2s-brushless-speed-controller.html?affiliate_code=BSFWYBUNYWDKXJN&_asc=2672935468