Mickey Pumpkin Main St. USA Tealight

thingiverse

UPDATE(2018/11/04): Take a look below. Went searching for this or something similar and couldn't find it. So I created it myself. Began with a uniform pumpkin source that was nice to work with. The final design isn't perfect, but it's good enough as is. Might need to make a diffuser for the tea light to get the best look. A bit late in the season, but better late than never to try. Make sure to print two of the top_small models, one for each ear pumpkin. Designed specifically for 36mm tea lights (Ashland from Michaels). Recut the hole at the bottom to fit your own lights perfectly. Might want to glue the tops on after cleaning out all the supports completely. UPDATE(2018/11/04): Added a Diffuser model. Check out the picture. This is for stacking/gluing onto the tea light to help its light reach the full pumpkin height/ears and block the view through the faces to the other side. Printed using Spiralize mode so it's only one layer thick, and it's suggested to use clear PLA if you've got it, but even matching orange PLA might work well too as an alternative. LIT pictures are using a Diffuser.