MGN12 SeeMeCNC Barbell Carriage for Delta Printer (D300VS and others)

thingiverse

MGN12 carriages now available for use with SeeMeCNC's barbells. To assemble each carriage, you will need the following components: * 4 McMaster M3 Heatserts (available at https://www.mcmaster.com/94180a331) * 4 M3x16 Screws (used to mount to MGN12H carriages) * 2 M3x20 Screws (installed on barbell) * 2 M3x12 Screws (used as belt retainers) * 1 M3x12 Screw (bottom stiffener screw) * 7 M3 washers This setup utilizes McMaster M3 Heatserts, requiring four per carriage. Two are used for the barbell, one for the belt tensioner screw, and one for the strengthening screw at the bottom of the block. This assembly is a drop-in replacement for existing carriages on an Ultibots D300VS. The use of 750mm long MGN12 rails is recommended. A helpful resource for aligning rails when mounting them can be found at https://www.thingiverse.com/thing:3962350. Additionally, consider checking out my Hemera mount, which also utilizes SeeMeCNC barbells, available at https://www.thingiverse.com/thing:4027625.