MG ZS EV charge port bung puller

prusaprinters

If you like this model, and you're feeling generous, please check out my Ko-Fi page here!Owners of a 2019-2021 MG ZS EV will be aware of how tricky it can be to remove the rubber bung protecting the charge port. Especially if your hands, or the bung are wet. Even if you have good hand mobility, gripping the flexible flanged part can be difficult. For those who may have hand mobility issues or hand differences, this could be a much more significant problem. This part is a single part, can be printed in any material you like, and should slide on to the bung. You can happily leave it on permanently. Just a warning, I did make the mistake of leaving one in a hot car, and it shrank and warped, meaning it would no longer go back on. Leaving it on the bung behind the charge port should be fine, it shouldn't get too hot there, and the bung itself should hold it in shape.I included holes in the design should you want to thread anything through or attach it anywhere.I'd recommend a minimum 3 walls for strength, but it shouldn't need too much in the way of infill.