MFD Nimbus 1800 - VTOL Conversion KIT

thingiverse

This project has been thoroughly tested and proven to be fully functional, operating at a flawless 100% efficiency. However, it remains a work in progress due to the incomplete documentation. - TILT SERVO & MOTOR MOUNT: Parts named as tilt_servo_..., front_motor_mount, and square_carbon_fiber_tube_15x15_... The servo mount is specifically designed for RDS3115MG 15kg 180 degrees servo: https://goo.gl/VYcuxr. The motor plate is engineered to hold Sunnysky X4112S 485 kv brushless motor. The carbon fiber tube used is "Square Carbon Fiber Tube 15 x 15 x 600 mm from (hobbyking SKU: 445000174-0. After measurement, the dimensions are 15,15 x 15,30 mm. You must print each part twice, once for the front-right motor and again for the front-left motor, as there are no differences between right and left. For each mount, you will need: - 1 x Square Carbon Tube 15 x 15 x 1 [LINK1]. - 4 x [TYPE5] x [METRICA5] mm screws to fix the adapter part1 to the wing. - 2 x [METRICA6] x [SIZE6] mm, to fix part2 adapter to the tube. - 4 x M2 x 35mm screws (optional M2 x 45mm + nut), to fix servos to the mount. - 1 x M4 x 30/35mm + nut, to fix the servo mount to the square carbon tube. - 4 x M2 x [SIZE1] mm + nut, to join motor plate with arms. - 1 x M6 x 20mm + nut, for the ESC. - 1 x M3 x [SIZE3] mm screws, to fix the ESC to the motor. - ESC & BEC ENCLOSURE: Parts named as esc_bec_... It has been designed to hold one Hobbywing XRotor Pro 50A 4-6S Brushless speed controller ESC: https://goo.gl/1yecm8, and plus one HENGE UBEC 6V 6A 2-6S BEC: https://goo.gl/1yecm8. You must print an enclosure for each wing, taking into account that each wing has different cover and fastener (right or left). Remove from the wing the original plastic cover for the wires. Place the cover on the wing and draw it. Place the enclosure on the wing and draw it. Make a hole for the enclosure. Remove 1 mm depth for the cover. Glue the enclosure into its hole. Put the ESC and BEC inside the enclosure, and solder all needed wires. Fix the cover to the enclosure using four M2 x 8mm screws. - REAR MOTOR: Parts named as rear_motor_... - LANDING GEAR ADAPTER: Parts named as landing_gear_... This is an adapter for this landing gear: https://es.aliexpress.com/item/1pcs-Carbon-Fiber-Landing-Gear-For-Electric-Fixed-Wing-RC-Airplane-Model-Extra-260-Series-30/32798217431.html. You also need two M4 x 12mm screws and its nuts. Print the adapter, insert the nuts and glue it to the bottom of the wood try after removing the epp cover. No holes in wood are needed, just glue the adapter to the wood (don't forget to insert the nuts). The landing gear is screwed to the adapater using the two M4 x 12mm screws and nuts. - VIDEOS: https://www.youtube.com/watch?v=W13qxR8fp58 https://www.youtube.com/watch?v=DnTamJpYr6w https://www.youtube.com/watch?v=jrWr9Ewhc7E https://www.youtube.com/watch?v=4_cgeUE4hE0