Metric tap and die case

thingiverse

I bought the Azuno tap and die set but it was without a case. I liked Ryans case but it didn't have room for the drills and the die spaces were hex shape.. This may work with other T&D sets. The front slider has a recessed track and the lower case has a hole for a cut down ball point pen spring and a BB. I put the spring in the hole and cut it off flush. This will detent the front slider. I set my build plate to 45 degrees, but my plate runs 6 degrees hot, so really 50 degrees. (checked with an Infrared Thermometer gun). So what ever works best for you. 7-14-23 I revised the top and bottom case and the slider to closer fit because when turned upside down some of the bit would fall out of the tray. You still might pad the case above the smallest taps.