Metric Nut-Driver Holder

prusaprinters

Holder for the DYN DYN2806 Dynamite 5 pc Metric Nut Driver Assortment you can get on Amazon. I found a few different versions but they were too big and bulky or didn't look like they would hold the drivers straight. I wanted something pretty solid that could sit on a desk, in a toolbox or hang on a wall. Holders are tapered for a snug fit so you can use this on a desk or mounted to a wall. The 3 smaller sizes fit from the top-down or clip-in. The slots are a friction fit so these are held very well. There are two versions. One with a back-plate and one just the holder that you'll need to drill holes-in to mount. Back is a little thicker than required but I like the weight of it. Can be printed flat as the overhang is not that bad on the cones. Print Settings Printer: FLSUN i3 2017 Version Rafts: NoSupports: No Resolution: .3Infill: 25% Filament: Amazon Basics PLA Orange Notes: Can be printed at .2 or .3 and any infil as it's not supporting a lot of weight. I thought about engraving the size but the drivers have the size on the handle and the bit - so I opted not-to. Category: Tool Holders & Boxes